Wegener Communications DVR395 사용자 설명서

  

Page 

17 

 

Page 17 of 30 

DVR395/DVR396-002 

This section provides information and procedures for powering up the unit. 

A four position DIP switch on the rear panel provides manual control and setup selection. Mode 
setting is as follows:  (In setting the DIP switches, "D" = down and "U" = up, "X" = don't care 
for this function). 

1  2  3  4 

 

U X X X 

NTSC Video System* 

D X X X 

PAL Video System* 

X U X X  

Modulator Channel 3   (MODEL SPECIFIC) 

X D X X 

Modulator Channel 2   (MODEL SPECIFIC) 

X X U X 

Normal video 

X X D X  

Color Bars, Tones 

X X X U  

LNB Power OFF 

X X X D  

LNB Power ON 

 

Set the switches to the settings appropriate for your system. 

*  The receiver must be set to the same format (NTSC or PAL) as the desired channel being  

 

received.  The receiver will not operate correctly with incompatible settings. 

The front panel indicators and controls are shown in 

Figure 4

 (Page 18) and 

Figure 5

 (Page 18), 

and described in 

Table 4

 (Page 17).