Q-See QSD42208 사용자 설명서

User Manual for Commercial Series Net DVR

Page

105

Total

121

8.2 Upgrade Mode

Use client software to upgrade the firmware file. You do not need to use ftp server

software. Please refer to the client software user manual for detailed information.

Use “FTP” function of “Upgrade” sub menu in “Utilities” menu. You need one host PC

to run FTP server software and place firmware file (digicap), and make sure DVR and

PC are in the same sub net.

Use “USB” function of “Upgrade” sub menu in “Utilities” menu. Please make sure the

firmware file (digicap) is placed under root directory of USB flash memory.

After you reboot DVR, if you can hear the startup sound, but can not see startup picture,

you can input shell commands under HyperTerminal. You need one host PC to run FTP

server and HyperTerminal software, and make sure DVR and host PC are in the same

sub net. Please use DTE cable to connect DVR will host PC.

Step 1: Setup and run HyperTerminal

The parameters are: Baud rate: 115200bps, Data bit: 8 bits, Stop bit: 1 bit,

Parity: No, Flow ctrl: None.

Step 2: Press "ctrl" and "u" keys of the PC keyboard. Do not release them.

Step 3: Switch the power supply of DVR off and on. In the HyperTerminal, the

following sentence appears: Please input [u/U] or [ESC] key, Release "ctrl" and "u"

keys.

Step 4: Press “u” key. In the message line of “IP address of NET DVR”, input any one

IP, just make sure DVR IP and FTP server IP are in the same sub net.

Step 5: In the message line of “IP address of the FTP server”, input the FTP server IP.

Step 6: In the message line of “Confirm? (y/n)”, press “y”. DVR will connect with that

FTP server, and download the firmware file (digicap) through the network. Please make

sure FTP server and firmware file are setup and run correctly. After upgrade finishes,

press any key to reboot DVR.