Q-See QSD42208 사용자 설명서

User Manual for Commercial Series Net DVR 

                                                                                                                                                                                           

Page 

83

 Total 

121 

 
 

There is one RS-485 port at DVR rear panel used for PTZ control. You can setup RS-485 

parameters to match your PTZ protocol. In main menu, move “Active Frame” to PTZ icon and 

press

【ENTER】key, you can enter into PTZ menu as follows:  

 

 

 

Select channel: Select one PTZ camera.  

 

RS-485 parameters: Including baudrate, data bit, stop bit, parity, flow control, etc. These 

parameters must be the same as those of PTZ. Protocol.  

 

PTZ address: Each PTZ has one different address. 

 

PTZ type:  DVR supports the following PTZ protocols: YouLi, LinLin-1016, LinLin-820, 

Pelco-p, DM DynaColor, HD600, JC-4116, Pelco-d WX, Pelco-D, VCOM VC-2000, NetStreamer, 

SAE/YAAN, Samsung, Kalatel-312, CELOTEX, TLPelco-p, TLHHX-2000, BBV, RM110, 

KC3360S, ACES, ALSON, INV3609HD, Howell, Tc Pelco P, Tc Pelco D, AUTO-M, AUTO-H, 

ANTEN,  CHANGLIN,  DeltaDome,  XYM-12,  ADR8060,  EVI-D30,  DEMO-SPEED, 

DM-PELCO-D, ST832, LC-D2104, HUNTER, A01, TECHYIN, WEIHAN, LG, D-MAX, 

Panasonic, KTD-348, infinova, PIH-7625, LCU, DennarDome, etc. Other PTZ protocols may be 

added through new firmware. 

Note: In DVR “PTZ” menu, if you select Pelco-P protocol, when you setup PTZ address, 

please use 1 number higher or lower then the Camera ID. For example, if camera ID is 2, the DVR 

PTZ address is set as ID 3.

 

Preset setup: Preset is using one number to represent the camera’s position, zoom, focus and 

iris. Move “Active Frame” to “Setup” button on the right side of “Preset” item, press

【ENTER】