Clam Corp 8060 사용자 설명서
6
- S t e p F i v e -
To “set” the tent, grasp the tent material at the rear of the shelter and pull it downward. Observe the
porch area of the tent lifting accordingly as you pull. When the U-Channel Molding is correctly installed,
the Porch Hoop Pole will lightly touch the floor.
porch area of the tent lifting accordingly as you pull. When the U-Channel Molding is correctly installed,
the Porch Hoop Pole will lightly touch the floor.
To achieve this condition, start by finding the center of the Molding. From behind the unit, pull the
midpoint of the Tent downward and fold the Tent material under the lip of the Base. Then press the
midpoint of the molding over the Tent material and Base lip. Continue pressing outward in both
directions until you have secured about twelve inches of material to the base
midpoint of the Tent downward and fold the Tent material under the lip of the Base. Then press the
midpoint of the molding over the Tent material and Base lip. Continue pressing outward in both
directions until you have secured about twelve inches of material to the base
Having temporarily secured the tent to the base, take a walk around the unit. Readjust the Molding until
you have verified the proper Porch Hoop Pole position and also that the Tent sides and corners are
properly proportioned.
you have verified the proper Porch Hoop Pole position and also that the Tent sides and corners are
properly proportioned.
When satisfied, continue applying the Molding around the shelter, one direction from center and then the
other, pulling the material as you go so that surface is relatively wrinkle-free and snug.
other, pulling the material as you go so that surface is relatively wrinkle-free and snug.
Secure the Molding with the included #6 Phillips Screws. Evenly space them about every ten to twelve
inches, and also put a screw in the center of both corners. Since there aren’t any predrilled holes, it's
advisable to use a powered driver for this operation.
inches, and also put a screw in the center of both corners. Since there aren’t any predrilled holes, it's
advisable to use a powered driver for this operation.