MotoSAT Nomad 2 사용자 설명서

 

3

 
 

 
1- 

Plug in all necessary cable connections to the back of the NOMAD 2 (see diagram 
on pg. 8).  Note:  Plugging the receiver and NOMAD 2 controller into an 
independent power strip is recommended.  

 

 

2- 

Connect coax from NOMAD 2 to Mount. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 

 

 

 
3- 

Set the satellite mode to which service you are using by using the Quick Guide for 
DirecTV, Dish Network, Etc. You will also need to know whether or not your 
unit is a non-skewable unit [Executive, Freedom], or a skewable unit [MD500, 
MHDTV]. To get into the satellite mode selector, have the Nomad power off, 
hold both the Find’ and ‘Stow’ buttons down and hit the Power Button, continue 
to hold down the Find and Stow button for an additional 5 seconds after power is 
on. Let go at this point and the front display lights will show the current satellite 
mode of the unit. Use the ‘Find’ and ‘Stow’ buttons to cycle through the light 
patterns until the desired configuration is shown. Turn the ‘Power’ off to store the 
programmed settings.   [See page 14 Satellite Mode Guide and page 17 Quick 
Guide for configurations and more detailed instructions] 

 
 
 
 

●    Dish Pro 500 (300,500,800) Series Receiver(s) are a  
      required component when using the Model MD500.