RCA Satellite TV Antenna 사용자 설명서

Final Installation

33

1. Drill a hole in the location you want the coaxial cable to enter.

2. Place some silicone grease on the connector and connect the

RG-6 coaxial cable that will extend from  the grounding block
to the receiver.

3. Make a 3” - 5” drip loop using cable clips at the grounding

block.

4. Route the coaxial cable through your house to the back of the

receiver.  You may route the coaxial cable through a floor or
wall or directly to the back of the receiver.  If you are routing
through a wall, you may choose to install a wall plate at the
point the coaxial cable enters the inside of the house and use
a third RG-6 coaxial cable.

5. Use a silicone sealant to seal all outside connections and the

hole you drilled for the coaxial cable to enter your house.

Step 3: Make a drip loop.

Step 2: Connect RG-6 cable to

grounding block.

Step 4: Route the cable

into your house.

Cable entry into house

RG-6 coaxial cable #2
(no messenger wire)

DSS receiver

TV

To Telephone Outlet

Grounding Block