Avaya IP Office Phone 사용자 설명서
Safety and Homologation Statements
Lithium Batteries - Page 57
IP Office Installation Manual
Safety and Homologation Statements - Page 57
40DHB0002USCL – Issue 9 (28th October 2003)
Lithium Batteries
Safety and Homologation Statements
CE Mark
The "CE" mark affixed to this equipment means that the unit complies with the 1999/5/EC
(R&TTE), 89/336/EEC (EMC) and 72/23EEC (LVD) Directives
Declaration of Conformity
The Declaration of Conformity (DoC) for the IP400 Office products is contained with in the
CD accompanying the products.
The "CE" mark affixed to this equipment means that the unit complies with the 1999/5/EC
(R&TTE), 89/336/EEC (EMC) and 72/23EEC (LVD) Directives
Declaration of Conformity
The Declaration of Conformity (DoC) for the IP400 Office products is contained with in the
CD accompanying the products.
This warning symbol is found on the base of IP401, IP403, IP416 and IP412
units and on the base of the IP400 Digital Station 80W Lump-in-Line PSU (see
page 24). Refer to page 59 for information concerning which Trunk Interface
module variants are fitted in which country.
units and on the base of the IP400 Digital Station 80W Lump-in-Line PSU (see
page 24). Refer to page 59 for information concerning which Trunk Interface
module variants are fitted in which country.
WARNING
The Avaya IP400 Office units are intended to be installed by 'Service Personnel' and
it is the responsibility of the Service Personnel to ensure that all subsidiary
interconnected equipment is wired correctly and also meet the safety requirements
of IEC60950 or UL60950 where applicable.
Lithium Batteries
A lithium battery is fitted to the real time clock on the IP401/403/406 and IP412 mother
boards.
boards.
WARNING
The Lithium battery must only be replaced by Avaya personnel or authorized
representatives. There is a danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
Lightening Protection/Hazard Symbols
Lightening protectors
The buildings lightening protectors must be verified as follow:
1. Check the lightening protectors, at the trunk cable entry point to the building housing
The buildings lightening protectors must be verified as follow:
1. Check the lightening protectors, at the trunk cable entry point to the building housing
the Avaya IP Office, paying special attention to the lightening protection grounding.
Report any problems, in writing, to the telephone company.
Report any problems, in writing, to the telephone company.
2. Equipment that is designed to be connected using internal wiring is typically not
lightening protected. Hence, Avaya IP Office extension cabling must not leave the
building. For installations where telephones and/or other standard (tip/ring) devices
are installed in another building then lightening protection is required (see page 36).
building. For installations where telephones and/or other standard (tip/ring) devices
are installed in another building then lightening protection is required (see page 36).
Hazard Symbol
The shock hazard symbol is intended to alert personnel to electrical hazard or
equipment damage. The following precautions must also be observed when
installing telephone equipment:
equipment damage. The following precautions must also be observed when
installing telephone equipment:
1. Never install telephone wiring during a lightening storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed
2. Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
3. Never Touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
4. Always use caution when working with telephone lines.