Polycom SIP 3.0.2 사용자 설명서

Administrator’s Guide SoundPoint IP / SoundStation IP 

A - 106

This flash attributes are defined as follows:

This feature is very powerful and should be used with caution. For example, an 

incorrect setting could set the IP Address of multiple phones to the same value.
Note that some parameters may be ignored, for example if DHCP is enabled it will 

still override the value set with device.net.ipAddress.
Individual parameters are checked to see whether they are in range, however, the 

interaction between parameters is not checked. If a parameter is out of range, an 

error message will appear in the log file and parameter will not be used.
Incorrect configuration could cause phones to get into a reboot loop. For example, 

server A has a configuration file that specifies that server B should be used, which 

has a configuration file that specifies that server A should be used.
Polycom recommends that you test the new configuration files on two phones 

before initializing all phones. This should detect any errors including IP address 

conflicts.

device.set

0 or 1

default = 0

If set to 0, do not use any device.xxx.yyy fields to 

set any parameters. Set this to 0 after the initial 

installation.
If set to 1, use the device.xxx.yyy fields that have 
device.xxx.yyy.set

 = 1. Set this to 1 for the initial 

installation only.

device.xxx.yyy.set

0 or 1

default = 0

If set to 0, do not use the device.xxx.yyy value.
If set to 1, use the device.xxx.yyy value.
For example, if device.net.ipAddress.set = 1, 

then use the contents of the device.net.ipAddress 

field.

device.net.ipAddress

dotted-decimal IP address

Phone's IP address.
Note: This field is not used when DHCP client is 
enabled.

device.net.subnetMask

dotted-decimal IP address

Phone's subnet mask.
Note: This field is not used when DHCP client is 
enabled.

device.net.IPgateway

dotted-decimal IP address

Phone's default router / IP gateway.
Note: This field is not used when DHCP client is 
enabled.

device.net.vlanId

Null, 0 to 4094

Phone’s 802.1Q VLAN identifier.
Note: Null = no VLAN tagging

device.net.cdpEnabled

0 or 1

If set to 1, the phone will attempt to determine its 

VLAN ID through the CDP.

device.dhcp.enabled

0 or 1

For description, refer to 

 on page 

.