Polycom SIP 3.0.2 사용자 설명서

Administrator’s Guide SoundPoint IP / SoundStation IP 

3 - 12

Syslog is a standard for forwarding log messages in an IP network. The term 
"syslog" is often used for both the actual syslog protocol, as well as the 

application or library sending syslog messages.
The syslog protocol is a very simplistic protocol: the syslog sender sends a 
small textual message (less than 1024 bytes) to the syslog receiver. The receiver 
is commonly called "syslogd", "syslog daemon" or "syslog server". Syslog 
messages can be sent through UDP, TCP, or TLS. The data is sent in cleartext.
Syslog is supported by a wide variety of devices and receivers. Because of this, 
syslog can be used to integrate log data from many different types of systems 
into a central repository.
The syslog protocol is defined in RFC 3164. For more information on syslog, 

http://www.ietf.org/rfc/rfc3164.txt?number=3164

 .

The following syslog configuration parameters can be modified on the Syslog 

menu:

The boot server can be on the local LAN or anywhere on the Internet.

Server Address

dotted-decimal IP address

OR

domain name string

The syslog server IP address or host name.
The default value is NULL.

Server Type

None=0,

UDP=1,

TCP=2,

TLS=3

The protocol that the phone will use to write to the syslog 

server. 
If set to “None”, transmission is turned off, but the server 

address is preserved.

Facility

0 to 23

A description of what generated the log message. For 

more information, refer to section 4.1.1 of RFC 3164.
The default value is 16, which maps to “local 0”.

Render Level

0 to 6

Specifies the lowest class of event that will be rendered to 

syslog. It is based on log.render.level and can be a 

lower value.
Refer to 

 

on page 

Prepend MAC 

Address

Enabled, Disabled

If enabled, the phone’s MAC address is prepended to the 

log message sent to the syslog server.