ZyXEL Communications EMG5324-D10A 사용자 설명서
Chapter 8 Routing
EMG5324-D10A User’s Guide
147
8.2.1 Add/Edit Static Route
Click add new Static Route in the Routing screen or click the Edit icon next to a rule. The
following screen appears. Use this screen to configure the required information for a static route.
following screen appears. Use this screen to configure the required information for a static route.
Figure 64
Routing: Add/Edit
The following table describes the labels in this screen.
Table 32
Routing: Add/Edit
LABEL
DESCRIPTION
Active
Click this to activate this static route.
Route Name
Enter the name of the IP static route. Leave this field blank to delete this static route.
Destination IP
Address
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Address
You can decide if you want to forward packets to a gateway IP address or a bound interface.
If you want to configure Gateway IP Address, enter the IP address of the next-hop
gateway. The gateway is a router or switch on the same network segment as the device's
LAN or WAN port. The gateway helps forward packets to their destinations.
gateway. The gateway is a router or switch on the same network segment as the device's
LAN or WAN port. The gateway helps forward packets to their destinations.
Bound
Interface
Interface
You can decide if you want to forward packets to a gateway IP address or a bound interface.
If you want to configure Bound Interface, select the check box and choose an interface
through which the traffic is sent. You must have the WAN interface(s) already configured in
the Broadband screen.
through which the traffic is sent. You must have the WAN interface(s) already configured in
the Broadband screen.
Apply
Click Apply to save your changes.
Back
Click Back to exit this screen without saving.