Mitsubishi Electronics QD75MH1 사용자 설명서
5 - 30
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
5.2.3 Detailed parameters 1
Setting value, setting range
Setting value buffer memory
address
Item
Value set with peripheral device
Value set with PLC
program
Default value
Axis 1 Axis 2 Axis 3 Axis 4
Pr.11
Backlash compensation
amount
amount
The setting value range differs according to the "
Pr.1
Unit
setting".
Here, the value within the [Table 1] range is set.
Here, the value within the [Table 1] range is set.
[Table 1] on right page
0 17
167
317
467
Pr.12
Software stroke limit upper
limit value
limit value
2147483647
18
19
19
168
169
169
318
319
319
468
469
469
Pr.13
Software stroke limit lower
limit value
limit value
The setting value range differs according to the "
Pr.1
Unit
setting".
Here, the value within the [Table 2] range is set.
Here, the value within the [Table 2] range is set.
[Table 2] on right page
–2147483648
20
21
21
170
171
171
320
321
321
470
471
471
0 : Apply software stroke limit on current
feed value
0
Pr.14
Software stroke limit
selection
selection
1 : Apply software stroke limit on
machine feed value
1
0 22
172
322
472
0 : Software stroke limit valid during JOG
operation, inching operation and
manual pulse generator operation
manual pulse generator operation
0
Pr.15
Software stroke limit
valid/invalid setting
valid/invalid setting
1 : Software stroke limit invalid during
JOG operation, inching operation and
manual pulse generator operation
manual pulse generator operation
1
0 23
173
323
473
Pr.11 Backlash compensation amount
The error that occurs due to backlash when moving the machine via gears can be
compensated.
When the backlash compensation amount is set, pulses equivalent to the
compensation amount will be output each time the direction changes during
positioning.
compensated.
When the backlash compensation amount is set, pulses equivalent to the
compensation amount will be output each time the direction changes during
positioning.
Workpiece
(moving body)
(moving body)
Worm gear
Backlash
(compensation amount)
(compensation amount)
Pr.44
OPR direction
1) The backlash compensation is valid after machine OPR. Thus, if the backlash
compensation amount is set or changed, always carry out machine OPR once.
2) "
Pr.2
No. of pulses per rotation", "
Pr.3
Movement amount per pulse" and
"
Pr.11
Backlash compensation amount" which satisfies the following (1) can
be set up.