Avaya VF 3000 사용자 설명서

 
The following section describes how to configure the Juniper VF 3000 SBC for LSP enterprise 
sites. Only the Signaling Card (SC) needs to be updated, not the Media Card (MC).  In a High 
Reliability (HA) configuration, both the master and backup (SC) needs to be updated. This 
document assumes that Juniper VF 3000 SBC basic provisioning has been performed. Refer to 
[2] for more information. The steps below are for enterprise site B1. 
 
Connect to the (SC) interface of the Juniper VF 3000 SBC via the console port or telnet to the 
management interface, which should already be administered.   
 
Step 1. Enter “privileged” mode to input configuration and management commands. Enter the 
“privilege” mode password. Enter command blade session-routing Æ then sr-policy (policy to 
be modified) then option Æ and then lsp-address <IP address> to add the Native LSP IP 
address to the sr-policy defined for enterprise site B1 as shown in Figure 45. 
 

 

 

 

TC; Reviewed: 
PV 04/24/2006 

Avaya – Proprietary 

Use as authorized only pursuant to your signed agreement or 

Avaya policy. No other disclosure is permitted or authorized. 

54 of 61 

HT3-LSP-VF.doc