Siemens A31008-A200-J101-2-7619 사용자 설명서

Gigaset A200 / IM eng / A31008-A200-J101-2-7619 / starting.fm / 12.06.2003

Place your handset in the base station with the display visible at the front – the con-

firmation tone will ring (rising sequence of tones). The handset will then register itself 

automatically with the base station (page 20), all symbols flashing in the display. The 

process takes about a minute. Once completed, "1" will appear in the top, left-hand cor-

ner of the display. This handset has been allocated the first internal number.
Only for A200 Duo: To register a second handset, proceed as described above. After 

successful registration, "2" will then appear in the top, left-hand corner of the display. 

Now leave the handset in the base station to allow the batteries to charge, since these 

are not charged prior to delivery. The battery charging process is indicated on the hand-

set by a flashing battery symbol 

=

.

Once the batteries have been charged, your phone is ready for service. You need to set 

the date and time to ensure that the time of incoming calls can be noted correctly 

i

◆

To register further handsets, see page 20 onwards.

=

 Flat batteries

V

 Batteries 

2

/

3

 charged

e

 Batteries 

1

/

3

 charged

U

 Batteries full

i

◆

For the first charging we recommend a continuous charging time as 

shown in the table (page 32) – regardless of the charging status 

shown in the display! Battery capacity reduces for technical reasons 

after a period of time.

◆

The batteries warm up during charging - this is normal and not a cause 

for concern.

◆

The correct charging status for the batteries will only be shown after 

an unbroken charging/discharging cycle. You should therefore not 

open the battery compartment unnecessarily.

◆

Once the first charging cycle is completed you can put your handset 

back in the base station after each call. Charging is controlled elec-

tronically. This ensures optimum battery charging without overload-

ing.