Siemens Gigaset SL56 사용자 설명서
25
Appendix
Gigaset SL56 / IM1 EN / A31008-M1752-R111-2-6Z19 / start_guide_time.fm / 24.7.07
Appendix
Care
Wipe the base station, charging cradle and
handset with a damp cloth (do not use
solvent) or an antistatic cloth.
Never use a dry cloth. This can cause
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove
1. Switch off the handset and remove
the battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your handset, visit us at any time at
The table below contains a list of common
problems and possible solutions.
Service (Customer Care)
We offer you support that is fast and tai-
lored to your specific needs!
Our Online Support on the Internet can be
Our Online Support on the Internet can be
reached any time from anywhere.
It provides you with 24/7 support for all
our products. It also provides a list of FAQs
and answers plus user guides and current
software updates (if available for the prod-
uct) for you to download.
You will also find frequently asked ques-
You will also find frequently asked ques-
tions and answers in the appendix of this
user guide.
The display is blank.
1. The handset is not switched on.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The battery pack is flat.
¥
Charge/replace the battery pack
The handset does not respond to a key press.
The keypad lock is activated.
The keypad lock is activated.
¥
Press and hold the hash key
#
!
"Base station x" is flashing in the display.
1. The handset is outside the range of the base
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 5).
3. The base station is not switched on.
¥
Check the base station mains adapter.
Base Search
is flashing in the display.
The handset is set for
Best Base
and no base sta-
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter.
Handset does not ring.
The ringtone is switched off.
The ringtone is switched off.
¥
Activate the ringtone (page 18).
The other party cannot hear you.
You have pressed the
You have pressed the
u
(INT) key. The hand-
set is "muted".
¥
Switch on the microphone again (page 8).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the instruc-
Watch the display and refer to the instruc-
tions if necessary.