Ferris Industries 5900301 사용자 설명서

Not for 

Reproduction

The cutting height adjustment pin (A, Figure 37) 
controls the mower cutting height.  The cutting height 
is adjustable between 1-1/2” (3,8cm) and 5” (12,7cm) 
in 1/4” (0,64cm) increments.

 1.  Depress the deck lift foot pedal (B, Figure 37) until 

it locks into the 5” (12,7 cm) position.

 2.  Place the cutting height adjustment pin in the 

desired cutting height.

 3.  Depress the deck lift foot pedal then push the lock 

lever (C) towards the right to release the lock.

 4.  Release the deck lift foot pedal until it comes to 

rest against the cutting height adjustment pin.

The deck lift foot pedal can be adjusted to 
accommodate the operator’s height for optimal 
comfort.

 1.  Remove the foot pedal (A, Figure 38) from the 

pedal mount tab (B).

 2.  Remove the pedal mount hardware (C) and rotate 

the tab 180 degrees.

 3.  Reinstall the pedal mount hardware and tighten 

securely.

 4.  Reinstall the foot pedal on the pedal mount tab in 

the proper orientation as shown in Figure 38.

This unit is equipped with a removeable floor pan 
which can be removed to provide better access to the 
mower deck.

 1.  Loosen and remove the knob (A, Figure 39) that 

secures the floor pan (B) to the frame of the unit.

 2.  Tilt the back end of the floor pan up and then 

remove it from the unit.

 1.  Reverse the removal procedure.

Troubleshooting, Adjustment & Service