Polycom VVX 300 사용자 설명서

다운로드
페이지 113
Copyright, Safety, and Regulatory Notices 
 
Safety, Compliance, and Disposal Information 
Part 15 FCC Rules 
This device is compliant with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: 
1  This device may not cause harmful interference, and 
2  This device must accept any interferences received, including interference that may cause 
undesired operation. 
Class B Digital Device or Peripheral 
Note: This equipment is tested and complies with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, 
uses, and can radiate radio frequency energy and, if not installed and used in accordance with 
the instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does 
cause harmful interference to radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the interference by one or 
more of the following measures: 
1  Reorient or relocate the receiving antenna. 
2  Increase the separation between the equipment and receiver. 
3  Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
4  Consult the dealer or an experienced radio/TV technician for help. 
Modifications 
In accordance with Part 15 of the FCC Rules, the user is cautioned that any changes or 
modifications not expressly approved by Polycom, Inc. could void the user’s authority to operate 
the equipment. This equipment may not be used on a coin service or party line.  
Installation Instructions 
Installation must be performed in accordance with all relevant national wiring rules. 
L’Installation doit être exécutée conformément à tous les règlements nationaux applicable au 
filage électrique. 
When using Power over Ethernet (PoE), the equipment is to be connected only to PoE networks 
without connections to the outside plant. 
Plugs Acts as Disconnect Device 
The socket outlet to which this apparatus is connected must be installed near the equipment 
and must always be readily accessible.