DKS Enterprises 1802 사용자 설명서

 

44 

 

The administrator can perform the following operations from a remote location using a touch-tone 
telephone.  You must know the phone number of the system and the system master code. 

 

1.  Call the telephone number that the entry system is installed on.  The system will answer 

with a short tone (beep).  Note: the number of rings before the system answers is 
dependent on the programming in 3.1.8.  

2.  After the system answers, follow the desired programming steps in Section 3.  

3.  When complete, hang up.  You cannot use 0# together to end the programming step from 

a touch-tone telephone. 

 

1.  Call the telephone number that the entry system is installed on.  The system will answer 

with a short tone (beep).  Note: the number of rings before the system answers is 
dependent on the programming in 3.1.8.  

2. Press 

 and enter the four-digit MASTER CODE 

BBBB

 (beep).  

3.  Press the desired tone open number 

B

 (beep).  NOTE:  Refer to 3.1.5 to determine 

which tone open features have been programmed, i.e. momentary open, hold open, 
release, hold open one hour and then release. 

4. Hang 

up. 

 

The telephone entry system can be called and a check can be made to determine if any of the relays 
in the system are in a "hold open" mode.  This check can be useful if yourr gate (or door) is held open 
and you suspect that the telephone entry system relay may be the cause. 

 

1.  Call the telephone number that the entry system is installed on.  The system will answer 

with a short tone (beep).  Note: the number of rings before the system answers is 
dependent on the programming in 3.1.8. 

2. Press 

 and enter the four-digit MASTER CODE 

BBBB

 (beep). 

3.  The system will emit a series of short tones if the relay is in a continuous activation mode. 

Relay 1 activated: 

beep - pause - beep - pause . . .  

Relay 2 activated: 

beep beep - pause - beep beep - pause . . .  

Relay 1 & 2 activated: 

beep beep beep - pause - beep beep beep - pause . . . 

4.  Press the programmed tone number 

B

 to deactivate the relay (beep).  The system will 

automatically hang up.