Avaya MDW 9040 사용자 설명서
2
Installing the MDW 9040 Pocket Phone System
Quick Installation Overview
MDW 9040 Wireless Pocket Phone Installation and Use,
503-801-190
12
Issue 2, February 2001
If your installation requires customized wiring, the wiring technician should match
the Pin numbers with the switch interfaces as shown in the following table.
the Pin numbers with the switch interfaces as shown in the following table.
Note:
A Dual Radio Module used with an MDW 9040 Wireless Pocket Phone
will NOT support a Tip/Ring [Plain Old Telephone Service (POTS)]
interface.
will NOT support a Tip/Ring [Plain Old Telephone Service (POTS)]
interface.
Positioning a Dual Radio Module
The radio modules for each zone of communication can be placed on a flat surface such as a desk or shelf for
ease of installation, OR mounted on the wall (higher is usually better). Use the following rules for positioning a
radio module in your system.
ease of installation, OR mounted on the wall (higher is usually better). Use the following rules for positioning a
radio module in your system.
The range depends on your particular operating environment. For indoor use, walls between the handset and the
radio module will reduce the phone’s range. Avoid concentrations of structural metal, such as steel and
aluminum, and reinforced concrete.
radio module will reduce the phone’s range. Avoid concentrations of structural metal, such as steel and
aluminum, and reinforced concrete.
General Positioning
Rules
Rules
Failure to observe the following rules regarding location and use will result in poor
performance of your MDW 9040 Pocket Phone.
performance of your MDW 9040 Pocket Phone.
•
The Synchronization cable connecting two radio modules is 20 inches
(50 cm) long.
(50 cm) long.
•
When positioning radio modules, they must be installed with a minimum
separation that is provided by the base “wings” of the radio module (5 1/4”). A
template for wall-mounting the radio modules is provided in Appendix E.
separation that is provided by the base “wings” of the radio module (5 1/4”). A
template for wall-mounting the radio modules is provided in Appendix E.
•
When wall-mounting the radio module, place it high on the wall for optimum
voice quality and range. Allow 6 to 12 inches (15.2 to 30.5 cm) of space between
the top of the antenna on the radio module and the ceiling.
voice quality and range. Allow 6 to 12 inches (15.2 to 30.5 cm) of space between
the top of the antenna on the radio module and the ceiling.
1 2 3 4 5 6 7 8
View of Line Jack
(with Dual Radio Module
upside down)
(with Dual Radio Module
upside down)
Dual Radio Module LINE 1 and LINE 2 Jack Wiring
Jack Pin #
SWITCH TYPE and Radio Module PEC CODE
PARTNER
3204-DRE
MERLIN
3204-DRE
DEFINITY
3204-DRD
MERLIN MAGIX
3204-DRD
1
–
Control Tip
–
–
2
–
Control Ring
–
–
3
Control Tip
Line Power Pos.
–
–
4
Voice Ring
Voice Ring
Ring
Ring
5
Voice Tip
Voice Tip
Tip
Tip
6
Control Ring
Line Power Neg.
–
–
7
Aux. Power Neg.
Aux. Power Neg.
Aux. Power Neg.
Aux. Power Neg.
8
Aux. Power Pos.
Aux. Power Pos.
Aux. Power Pos.
Aux. Power Pos.