Avaya MDW 9040 사용자 설명서

MDW Wireless Pocket Phone Installation and Use, 

503-801-190

Issue 2, February 2001

Place the mounting plate against the wall, and align the screw holes on the plate 
with the holes that you have marked on the wall. Start the screws, and screw them 
in until the plate rests flush against the wall.

Place the keyhole-shaped openings on the back of the radio module over the 
screw heads, then slide the radio module downward until it locks into place.

Follow the installation procedures for “

,” or “

.”

To install one radio module on a desk or shelf:

Remove the radio module from its shipping box and place it in the location you 
have selected (for wall-mounting instructions, see “

).

For the first handset to be connected to the radio module, connect a 14 foot
(4.2 m) Station Line Cord (provided) to Line 1 on the radio module and then 
connect the other end of the cord to a station port at the main communication 
system. If a second handset is to be connected to the radio module, connect 
another Station Line Cord to Line 2 on the radio module and then connect the 
other end of that cord to another station port.

If the radio module cannot be connected to an associated switch, it can be 
temporarily connected to an auxiliary power supply that can provide 
electrical power.

Verify that the radio module has power and that the status LED information is 
correct. See “

.

Proceed to “

Two or more radio modules must be connected so that their transmission and reception signals will be 
synchronized. In this way, the signals transmitted to or received by one radio module will not interfere with 
another. This synchronization can be done in a single zone (see below) or a dual zone configuration (see

).

Screw
Holes

Wall-mounting Plate