AltiGen comm ACM 5.1 사용자 설명서

Chapter 12:  Trunk Configuration

AltiWare ACM 5.1 Administration Manual 157

To open a configuration dialog box for a Triton T1/E1 channel, do one of the following:

•

If you’re in the Trunk Configuration window, select a Triton T1/E1 channel from 
the trunk channels list, then click the Trunk Properties button, or just double-click 
the channel in the list.

•

If you’re in the Trunk View window, right-click the channel and select Channel 
Properties.

Figure 6. Triton T1 Configuration dialog box

Following are the parameters for the Triton T1 Configuration dialog box:

You can set Protocol to one of the following: 

•

E&M Wink Start (default)

•

E&M Immediate Start

•

Ground Start

•

Loop Start

For signaling from one board to another, only E&M Wink 
Start is supported. Loop Start, Ground Start, and E&M 
Immediate Start protocols cannot be used for interfacing 
between two boards.

Specifies the delay, in milliseconds, after trunk seizure and 
before digit dialing. This configuration will slow down the 
system transmitting digits to the CO by a defined delay to 
avoid missing digits. Do not change this value unless advised.