AltiGen comm ACM 5.1 사용자 설명서

다운로드
페이지 454
AltiWare ACM 5.1 Administration Manual 263
C
H A P T E R
20
Paging Group Configuration
The IP paging group is a group of IP phones that can receive station paging. This feature 
also can be used as IP zone paging by creating multiple paging groups.
Implementation details:
The paging signal uses AltiGen's proprietary H.323-ATPS protocol. You need to have 
H.323 tie-trunk channels to be able to implement IP paging. 
Each paging session requires one G.711 codec channel. The voice stream is multicast 
to multiple IP phones on the LAN.  
Any extension (analog or IP) can initiate a paging call by dialing #46 + the Paging 
Group number.
When paged, an IP phone in idle state will automatically turn on the speaker, play a 
beep, and then play the page.
When receiving an incoming call during a paging session, the IP phone will 
automatically stop the paging session and start ringing.
The IP phone user can terminate a paging session by pressing the Release key on 
the phone.
To configure paging, select PBX > Paging Group Configuration.