Sony PT-4743 사용자 설명서

다운로드
페이지 104
4 l
I
N STALLATION
E
N
G
L
IS
H
Installation
Television Location
This unit can be used as part of an entertainment center.
 Consult
your dealer for available options.
Avoid excessive sunlight or bright lights, including
reflections.
Keep away from excessive heat or moisture. Inadequate
ventilation may cause internal component failure.
Fluorescent lighting may reduce remote control
transmitting range.
Keep away from magnetic equipment, including motors,
fans and external speakers.
Optional Cable Connections
Shielded audio and video cables should be used between
components. For best results:
Use 75-ohm coaxial shielded cables.
Use appropriate input and output connectors, that match
your component connectors.
Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION:   TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT
OF AC OUTLET AND FULLY INSERT. DO NOT
USE A PLUG WITH A RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE. 
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED
OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,
CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT
FROM THE APPARATUS.
Cable / Antenna Connection
For proper reception, either a cable or antenna connection
is required.
Cable Connection
Connect the cable supplied by your local
cablecompany to ANT1 connection on
back of television. Select cable mode and
ANT1 in SET UP menu under Prog Chan
(Program Channels).
Note:
A cable converter box may be
required for proper reception.
Check with your local cable company for compatibility
requirements.
Antenna Connection
For proper reception of VHF/UHF channels, an
external antenna is required. For best reception an
outdoor antenna is recommended.
Connect home antenna to
ANT1 connection on  back of
television. Select TV mode
and ANT1 in the SET UP
menu under Prog Chan. 
 
 
Note:
Cable Mode is preset at the
factory. Antenna users must
change to TV Mode and ANT 1 in the Set Upmenu.
Auto Set Up Menu
For your convenience, Auto Set up menu will be displayed
on screen when the set is turned on for the first time. If
needed, follow the menus and procedures for setting up the
features.
IDIOMA/LANGUE
To change menu language to ENGLISH, SPANISH or
FRENCH.
Procedure
Press VOL 
u to select English, Spanish or French.  
MODE
To select TV (antenna) or CABLE mode depending on the
signal source. 
Procedure
Press VOL 
u to select TV or CABLE.  
AUTO PROGRAM
To automatically program all channels with a signal.
Procedure
Press VOL 
u to start Auto Programming. 
CONVERGENCE
To adjust the center convergence, if needed. 
Procedure
Press VOL 
u to display center Convergence adjustment
menu.
Refer to page 27 for setting Convergence, if needed.   
Polarized plug
75 Ohm VHF/UHF
on back of TV
Incoming Cable from
Cable Company
Incoming Cable from
Home Antenna
new2prod 0470-1 E doc2.fm  Page 4  Friday, May 2, 2003  12:31 PM