Sony 2-059-370-14(2) 사용자 설명서

KDF-WE/WF655
2-059-370-14 (2)

Use this hookup if:

❑

Your cable TV company scrambles some channels, but not all of them 
(pay channels vs. regular cable channels) and you need to use a cable 
box.

❑

You want to enjoy the Twin View feature.

With this setup you can:

❑

Use the LCD projection TV’s remote control to change channels on 
your cable box when the signal is scrambled. To program your Sony 
remote control to operate your cable box, see “Programming the 
Remote Control” on page 62.

❑

Use the LCD projection TV’s remote control to change channels on 
your LCD projection TV when the signal is not scrambled. Your LCD 
projection TV’s tuner provides a better signal than the cable box.

❑

Use the Twin View feature. (When all channels are routed through your 
cable box, only one signal is sent to the LCD projection TV, so you 
cannot use the Twin View feature.)

Connect the CATV cable to the single (input) jack of the splitter.

Using a coaxial cable, connect one of the splitter’s two output jacks to 
the LCD projection TV’s CABLE jack.

Using a coaxial cable, connect the splitter’s other output jack to the 
cable box’s input jack.

Using a coaxial cable, connect the cable box’s output jack to the VCR’s 
RF input jack.

Using an A/V cable, connect the cable box’s A/V output jacks to the 
LCD projection TV’s A/V input jacks.

Using an A/V and S VIDEO cables, connect the VCR’s AUDIO and 
S VIDEO OUT jacks to the LCD projection TV’s AUDIO and S 
VIDEO IN input jacks.

Run Auto Program, as described in “Setting Up the LCD Projection TV 
Channel List” on page 58.

✍

To view scrambled channels, tune the LCD projection TV to the channel 
the cable box is set to (usually channel 3 or 4) and then use the cable 
box to switch channels.

01COV.book  Page 40  Thursday, February 17, 2005  8:01 PM