Samsung HL-T5655W 사용자 설명서

  The lamp used in a DLP TV has a limited lifespan. For the best screen quality it needs to be replaced periodically. After replacing the 

lamp, the screen quality will be bright and clear as new.

•  It should be replaced when the screen becomes darker, less clear or when all three LEDs on the front (STAND BY/TEMP, LAMP, and 

TIMER) are flashing.

•  The lamp must have the same code number and type.

•  The lamp type is indicated on the right side of the TV. It is also indicated on the lamp case.

•  After checking the code number for the lamp, give the code number to the store where you purchased the TV or to a Samsung Service 

center.

•  Replace with the correct code numbered(BP96-01472A) lamp to avoid damage to the TV.

•  Turn the power off and wait for 30 minutes before replacing the lamp as it will be hot.

•   Do not touch the glass part of the lamp with your bare hands or insert any foreign object inside the cover as it may cause poor screen 

quality, electric shock or fire.

•  Do not place the old lamp near flammable objects or within the reach of children.

•   Be sure to connect this TV directly to an AC wall outlet. If the TV’s AC plug is connected to a cable box or other source, it will not allow 

for proper cool down time.

• For replacement, you will need a 5.91-Inch screwdriver and a pair of gloves.
1  Unplug TV, then use a screwdriver to remove the screws.

 
2  Remove the Lamp cover.

3  Remove the Lamp cover duct holding the word clip and pulling it 

out.

4  Remove the screw securing the Lamp by using a screwdriver.

5  Separate the Lamp from the engine by holding the handle and 

pulling it out.

➢

  •  Be sure the replacement Lamp is the same type.

  •  After replacing the lamp, align the lamp cover with the 

groove and secure the screws.

  •  The TV will not turn on if the lamp cover is not correctly 

closed (as this will activate the protective circuit).

BP68-00626D-00Eng-2.indd   57

2007-04-13   ｿﾀﾈﾄ 1:20:47