Samsung PCJ 534RF 사용자 가이드
3
Press VOL + again.
The TV will begin
memorizing all of the
available channels.
The TV will begin
memorizing all of the
available channels.
4
After all the available
channels are stored, the
Auto program menu
reappears. Press Menu
three times to exit.
channels are stored, the
Auto program menu
reappears. Press Menu
three times to exit.
3.6
C
HAPTER
T
HREE
: TV O
PERATION
O
P E R AT I O N
Storing Channels in Memory (Automatic Method)
▼
The TV automatically cycles
through all of the available channels
and stores them in memory. This
takes about one to two minutes.
and stores them in memory. This
takes about one to two minutes.
Press VOL+ at any time to interrupt
the memorization process and return
to the Setup menu.
the memorization process and return
to the Setup menu.
2
Press VOL + while
“Channel set up” is high-
lighted. A new sub-menu
will appear, and “Auto
program” will be
highlighted.
“Channel set up” is high-
lighted. A new sub-menu
will appear, and “Auto
program” will be
highlighted.
1
First, select the correct
signal source (ANT, STD,
HRC, IRC). See steps 1~4
on previous page.
signal source (ANT, STD,
HRC, IRC). See steps 1~4
on previous page.
Press MENU, then press
CH
CH
▼ twice to highlight
“SET UP.”
Press VOL + to access
the SETUP sub-menu.
“Channel set up” will be
highlighted.
the SETUP sub-menu.
“Channel set up” will be
highlighted.
Note: Channel auto program does not function when the
V-chip is active.
V-chip is active.
00583F(E)-CHAPTER 3 7/19/05 2:32 PM Page 6