Samsung HCN436W 사용자 설명서

C

HAPTER

O

NE

: Y

OUR

N

EW

TV

1.4

Y

O U R

N

E W

T V

Use the rear panel jacks to connect an A/V component that will be connected continu-
ously, such as a VCR or a DVD player. 

Because there are two sets of input jacks, you can connect two different A/V components
(i.e., a VCR and a DVD, 2 VCRs, etc.)

For more information on connecting equipment, see pages 2.1 – 2.10.

Œ ANTENNA terminals 

Two independent cables or antennas can be 
connected to these terminals. Use ANT-A and
ANT-B terminals to receive a signal from VHF/
UHF antennas or your cable system. 
Use the ANT-A OUT terminal to send the signal
being received by the ANT-A terminal out to 
another component (such as a Cable Set Top Box).
The PIP channel can be received only when 
a signal source is connected to ANT-A.

´ AUDIO-VIDEO MONITOR

Connect to the audio/video input jacks of 
a recording VCR.
Note: The monitor out does not operate 
in DVD or DTV mode.

ˇ VIDEO INPUT jacks 

Connect to the video output jacks of VCRs, 
DVD players and similar devices (Two sets 
are available: Video1 and Video2).

¨ AUDIO INPUT jacks 

Connect to the audio output jacks of VCRs, 
DVD players and similar devices.

ˆ S-VIDEO INPUT jack 

Connect to an S-VHS VCR or DVD player.

Ø COMPONENT 1(480i, 480p,

Connect a source that outputs 480i/480p/1080i Y,P

B

and P

R

signals, such as a DVD (or DTV Set-Top Box.

∏ DIGITAL INPUT (Digital

Receives the digital video signals from a set top
box. (The DVI jack is not available on PCN5425R.)

” COMPONENT 2, 3(480p,

Connect a source that outputs 480p/1080i Y, 
P

B

and P

R

signals, such as a DTV Set-Top Box.

(Component3 jacks ; Depending on the model)

’ DVI AUDIO INPUT jacks 

Receives the digital audio signals from a set top
box.

00054A-02-CHAPTER 1  2004/10/19  12:34 PM  Page 4