Avaya S8400 사용자 설명서
Chapter 6: IP interface configuration
52
Installing and Configuring the Avaya S8400 Media Server
February 2006
10. Telnet to 192.11.13.6 and login.
11. Enter show control interface.
The IP address, subnet mask, and default gateway information is displayed.
Verify that the proper information was entered.
Verify that the proper information was entered.
12. If a default gateway is used, enter the gateway IP address with
set control gateway gatewayaddr
, where gatewayaddr is the customer-provided
IP address for their gateway.
13. Enter quit to save the changes and exit the IPSI session.
14. Telnet to 192.11.13.6 and login.
15. Use show control interface to verify the administration.
16. Type exit and press Enter to see the changes.
Setting the VLAN and diffserv parameters
1. Log in as craft.
2. Enter show qos to display the quality of service values.
3. If necessary, use the following commands to set the VLAN and diffserv parameters to the
recommended values shown.
Note:
Note:
Use Help to obtain syntax guidelines for these commands.
●
Enter set vlan priority 6
●
Enter set diffserv 46
●
Enter set vlan tag on
●
Enter set port negotiation 1 disable
●
Enter set port duplex 1 full
●
Enter set port speed 1 100
4. Enter show qos to check the administered values.
5. Enter quit to exit.
!
Important:
Important:
Ensure that the port settings on the Ethernet switches are set to the same values
as shown above in these set port commands. Log in to the Ethernet switch
and enter show qos.
as shown above in these set port commands. Log in to the Ethernet switch
and enter show qos.