Avaya S8100 사용자 설명서
6
Hardware additions
Add C-LAN functionality
S8100 Installation and Upgrades
231
November 2003
Install the TN799DP
To install a TN799DP C-LAN circuit pack, you need the following items:
•
An unoccupied port slot
•
A 10 BaseT Ethernet connection into your local area network
•
A valid, unused IP addresses on your network for each C-LAN circuit pack
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799DP circuit pack is hot-swappable, so you do not need to power down the
carrier to install it.
carrier to install it.
From the rear of the cabinet:
1
Connect the 259A connector to the backplane connector corresponding to the TN799DP slot.
2
Connect one end of the CAT5 cable to the 259A connector. Connect the other end to the
customer’s network.
customer’s network.
From the front of the cabinet:
1
Insert the TN799DP circuit pack into the port slot identified earlier.
Administer the TN799DP on the SAT
1
Type change node-names ip and press Enter.
2
In the Name and IP Address fields, type a name and IP address for each PC that will be dialing
into the C-LAN circuit pack; up to 8.
into the C-LAN circuit pack; up to 8.
change node-names ip
Page 1 of
1
NODE NAMES
Name IP Address Name IP Address
clan2
NODE NAMES
Name IP Address Name IP Address
clan2
135.9 .167.179 . . .
default 0 .0 .0 .0 . . .
clan1
clan1
192.168.10 .21
. . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .