Uniden POLARIS 사용자 설명서
23
4.
Rotate the PUSH – SELECT knob to
select the individual you want to
contact, and press the PUSH –
SELECT knob.
select the individual you want to
contact, and press the PUSH –
SELECT knob.
5.
Press the PUSH – SELECT knob to
transmit the individual DSC signal.
transmit the individual DSC signal.
6.
When you receive the individual
acknowledgment successfully, the
following screen appears, and both
radios tune to the previously
selected channel. You are now
ready to transmit on that channel.
or
When the called radio has been set
to standby mode, the following
screen appears.
acknowledgment successfully, the
following screen appears, and both
radios tune to the previously
selected channel. You are now
ready to transmit on that channel.
or
When the called radio has been set
to standby mode, the following
screen appears.
Note:
If there is not any data registered in the directory you cannot
proceed to the 3rd step. See the SETUP section for directory
setup instructions.
Select an open (unused) working channel first, then make the
call. After the acknowledgment, both radios tune to the
previously selected channel.
proceed to the 3rd step. See the SETUP section for directory
setup instructions.
Select an open (unused) working channel first, then make the
call. After the acknowledgment, both radios tune to the
previously selected channel.
1-B. GROUP
1.
Press and hold H/L/MENU for
2 seconds.
2 seconds.
2.
Press the PUSH – SELECT knob at
DSC CALL
, the DSC CALL menu
appears.
JUNE BRAWLEY
KENT NEWMAN
PAUL HUBER
EXIT
INDIVIDUAL
KENT NEWMAN
012345678
SEND
CANCEL
HI CAN
SHIP-SHIP
DSC CALL
SYSTEM
SETUP
REV.CH.MEM
EXIT
INDVL ACK
KENT NEWMAN
012345678
COMPLETED
INDVL ACK
KENT NEWMAN
012345678
UNATTENDED
POLARIS_UT888ZL_UT01888ZA_0 10/3/02 4:18 PM Page 23