Uniden EXP1240 사용자 설명서

EXP1240 System Installation Guide

Revision 06

PROPRIETARY AND CONFIDENTIAL

Page 35 of 71

∘ The

IP Status field

of the base station you are logged into should show

This

unit

. Any other base stations in this chain should show

Connected

(i.e.,

connected to the network and functioning properly) as their IP status. If any
base station shows

Connection Loss

as its IP status, that base station is not

connected to the network or has lost power.

∘

The primary base station always serves as its own sync source, so the

DECT

sync source

field should display

Primary:RPN{its own RPN}.

The

DECT

Property

field shows

Primary

∘

This base station's

DECT sync source

will show

(any) RPN

and its

DECT

Property

field will show

Locked

∘ Check the

DECT sync source

drop-down box for this base station to verify

that there is a selection for the primary base station with a dBm value. If
there is not a dBm value, wait for the system to further synchronize
(approximately 2 minutes). When there is a dBm value, select the primary
base station from the

DECT sync source

drop-down box and click

Save.

∘ If the primary base station is not on the list or if the signal strength is below -

70 to -73 dBm (-74dBm or less), move this base station to a different
location. (You could also configure the other Level 1 base stations first and
then come back and configure this one at Level 2.)

∘ The

DECT Chain

appears at the bottom of the display and shows the

synchronization source for all base stations in this system. Until the primary
base station is selected as the

DECT sync source

, there will be a warning in

the

DECT Chain

for this base station.

Figure 26:

Base Station Group

table, synchronization complete (

Multi-cell

screen)

13) When the system has finished synchronizing, repeat this process for each base station at

Level 1.