Sunrise Medical Quickie S-525 사용자 설명서

930486 Rev. A

930486 Rev. A

FRAME ONLY) (OPTIONAL)
Quickie S-525 wheelchairs are shipped
with backrest in folded position.

a) Lift backrest to upright position so

that latches (A) lock into place.

b) Backrest is ready for use.

a) Lift and turn backrest latch handles

(B) outward.

b) Fold backrest forward.

AND CONTOUR SEATS ONLY)
The seat depth can be adjusted in one
inch increments.

a) To adjust, remove the two bolts (A)

from each side of the backrest pivot
plate.

b) Reposition the backrest to the desired

position.

c) Replace and retighten bolts on each

side of the backrest pivot plate.

a) Remove bolts (B) on the seat hingeplate.
b) Adjust the set back to desired position.
c) Refasten bolts (B) in appropriate loca-

tion.

A backrest angle-adjustment is standard
on the Contour seat, the Highback
Contour seat, and the Seat Frame.

a) Remove the front securing bolt (C) on

the side of the backrest hinge plate.

b) Loosen the lower rear bolt (D)
c) Set at desired angle.There are four

holes (in 4º increments) to choose from.

d) Reinstall the front bolt (C) and

tighten both bolts securely.

a) The contour seat is shipped with a

seat-to-back angle of 100º and a back
height of 18"

b) To increase the seat-to-back angle,

adjust stop bolt (E) to desired loca-
tion. Do the same for the other hinge.

c) To decrease the back height, remove hinge

bolt from hole (F) and replace bolt in hole
(G). Do the same for the other hinge.

Note: Adjusting the back height will change

the seat-to-back angle. Follow instructions to

adjust the seat-to-back angle accordingly.

Note: Adjustment on both sides of the wheel-

chair must be equal.

a) Pull lever (H) upwards.
b) Lean back to desired position.
c) Release lever (H).