Maxon Telecom WL7-VERS. C-1K 사용자 설명서

 

32

11921 Slauson 

A

ve.  Santa Fe Springs, CA.  90670  (800) 227-41

16  F

AX (888) 771-7713

4.   Cut any excess wire from long power cable. 

Strip 1/2” insulation from the cut end and 
install 2 GA terminal lug and shrink tubing. 
Next, insert the power cable through the 
protective cover (FIG. 32-1). Connect the 
cable terminal to the terminal stud on the 
power input bracket as shown in FIG. 32-
1. Position the protective cover over the 
power cable connection (FIG. 32-1).

5.   Route the interlock cable from safety interlock 

system on the vehicle, underneath vehicle fl oor 
and through the grommet, and up to the Lift (FIG. 
32-2). If possible, use the same cable routing as 
the long power cable installed in previ-
ous steps. Secure the interlock cable 
every 8”-10”. 

6.   Make sure interlock cable will reach 

the white-red stripe wire (interlock 
signal from vehicle) and the brown 
wire (interlock signal to vehicle) on 
the Lift (FIG. 32-2). Signal may 
be ground or V+. Connect the inter-
lock wires from the vehicle interlock 
system to the white-red stripe wire 
and brown wire on the Lift (FIG. 
32-2).