Polycom 1725-36055-001 사용자 설명서
Field Verified
Configuration Guide
PN: 1725-36055-001_G.doc
6
Access Point Configuration
1. Connect to the AP.
2. If the AP is already in use, note the IP address, subnet mask,
2. If the AP is already in use, note the IP address, subnet mask,
default gateway, and WEP settings:
a. From the main menu select
a. From the main menu select
Setup > Ethernet > Identification
to
display or modify current settings for IP address, subnet mask,
or default gateway.
or default gateway.
b. From the main menu select
Setup > AP Radio > Hardware
to
display or modify current settings for ESSID and frequency.
c. From the main menu select
Setup> Security > Radio Data
Encryption (WEP) > Accept Authentication Types
to display or
modify current settings for encryption.
3. If allowable, set the AP configuration parameters to the default
values:
If you are concerned whether default values will affect any
operation of your existing WLAN please consult SpectraLink
Customer Support for specific field default values that we
recommend.
operation of your existing WLAN please consult SpectraLink
Customer Support for specific field default values that we
recommend.
a. From the main menu select
Setup > Ethernet > Advanced >Restore
Defaults
.
b. From the main menu select
Setup > AP Radio > Advanced >Restore
Defaults.
4. If 2 Mb/s support is desired:
a. Navigate to
Data Rates: 2.0
.
b. Change value to
basic
.
5. Navigate to the appropriate menu and enter the IP addressing,
subnet mask, default gateway, ESSID, and frequency information.
It is recommended that the AP allow the broadcast of ESSIDs to
simplify the configuration of SpectraLink 8000 Wireless Telephones.
SpectraLink terms this function Automatic Learn. If there are
overlapping WLAN areas at your site, the Automatic Learn function
may not work properly in the areas that receive signals from two or
more APs.
simplify the configuration of SpectraLink 8000 Wireless Telephones.
SpectraLink terms this function Automatic Learn. If there are
overlapping WLAN areas at your site, the Automatic Learn function
may not work properly in the areas that receive signals from two or
more APs.
Sites with heightened security issues may not want ESSID
broadcast enabled. If it is not enabled, the ESSID must be
programmed into every handset.
broadcast enabled. If it is not enabled, the ESSID must be
programmed into every handset.