Cobalt Networks 9034 사용자 설명서

••••  (V 2.0) 

If you are installing the card in a 8310-C-BNC or 8310-BNC frame (one with a 100 BNC rear module 
installed across the entire back plane), skip this section. 

If you are installing the card into a slot with no rear module, you should have ordered and received one 
of the following modules; RM-9034-A, RM-9034-B, RM-9034-C, or RM-9034-D. You will need to 
install it in your 8310 frame before you can connect cables. 

Use the following steps to install a rear module in an 8310 openGear

TM

 frame: 

1.  Refer to the openGear

TM

 8310 frame Owner’s Manual, to ensure that the frame is 

properly installed according to instructions.   

2.  On the rear of the 8310, locate the card frame slot. 

3.  As shown in Figure 2, seat the bottom of the rear module in the seating slot at the 

base of the frame’s back plane. 

 

4.  Align the top hole of the RM-9034-A with the screw hole on the top edge of the 8310 

back plane. 

5.  Using a Phillips driver and the supplied screw, fasten the rear module to the 8310 

back plane. Do not over tighten. 

 

All modules are installed using the same method above.   

The following section contains a table of all of the optional rear modules available for the 9034.