Land Pride rcf3696 Manual Do Utilizador

11

12/15/15

Refer to “Torque Values Chart” on page 56 to 
determine correct torque values for common bolts. See 
“Additional Torque Values” at bottom of chart for 
exceptions to standard torque values.

Refer to Figure 1-2:
A vent plug is shipped loose and packaged with the 
Operator’s Manual. Remove temporary solid plug on top 
of T-box and replace with included 3/8" vent plug. See 
your nearest Land Pride dealer if vent plug is missing. 

Refer to Figure 1-3:
Vented dipsticks are shipped loose and packaged with 
the Operator’s Manual. See your nearest Land Pride 
dealer if dipstick is missing. Remove temporary pipe plug 
from top of each gearbox and replace with supplied 
dipsticks.

IMPORTANT: Rotary Cutters are shipped with a 
solid plug in the gearbox to prevent loss of oil during 
shipping and handling. The solid plug on top of the 
gearbox must be replaced with a vented dipstick. Do 
not operate cutter without vented dipstick installed.

22320

 

30216

OVERFILL! 

The RCF36 Series cutters can be purchased with either 
3-point hitch, Semi-Mount hitch, or Pull-Type hitch. 

Refer to illustrations on cover of manual:
The 3-point Rotary Cutter is attached to the tractor’s 
lower 3-point arms and upper center link. The lower 
3-point arms are hydraulically adjusted to the cutting 
height. The height of the rear tailwheels are manually or 
hydraulically adjusted depending upon which option the 
cutter is set-up with. The tailwheels should be adjusted to 
hold the cutting blades slightly higher at the back than at 
the front. The “3-Point Assembly & Set-Up” instructions 
begin on page 12.

The Semi-Mount cutter is attached to the tractor’s lower 
3-point arms and have more freedom to float over uneven 
terrain than does the 3-point mounted cutter. The lower 
3-point arms are hydraulically adjusted to the cutting 
height. The rear tailwheels are manually adjusted with a 
ratchet jack or hydraulically adjusted to hold the cutting 
blades slightly higher at the back than at the front. The 
“Semi-Mount Assembly & Set-Up” instructions begin 
on page 17.

Refer to illustrations on Cover
The Pull-Type cutter is attached to the tractor drawbar. 
Cutting height is controlled with a hydraulic cylinder or 
ratchet jack. Leveling rods keep the rear of the cutter 
slightly higher than the front. The “Pull-Type Assembly 
& Set-Up” instructions begin on page 22.