Stamina Products 55-4286 Manual Do Utilizador
ASSEMBLY INSTRUCTIONS
8
STEP 4
Remove the paper covering from the foam tape inside the
FRONT COVER(3) and REAR COVER(4).
Place the
FRONT COVER(3) over the end of the FRONT FRAME(1). Place the REAR COVER(4) over
the end of the
REAR FRAME(2). Press the covers securely in place.
NOTE: The securing SCREWS(M6x1x35mm)(36) for the PULLEY SET(22) on each side may need
to be loosened to allow the
REAR COVER(4) to fit securely over the frame. Refer to the inset
illustration. When retightening the screws for the
PULLEY SETS(22) do not over tighten. The
PULLEY SETS(22) should swivel freely.
STEP 5
Insert the
FOAM PAD ASSEMBLIES(17) into the holes located on the CARRIAGE(7).
STEP 6
Insert the
FOOTBAR(5) into the mounting holes located on the FRONT FRAME(1). The FOOTBAR(5)
should pass through the
FRONT COVER(3) and the FRONT FRAME(1).