Roland VC-30HD Manual Do Utilizador

Appendices

Is a format supported by the VC-30HD being input?

The VC-30HD does not support up/down scalling, interlace/progressive (I/P) conversion, 
or frame rate conversion. The [OUTPUT FORMAT] indicators flash when the input and 
output formats are not compatible. No output is possible while the [OUTPUT FORMAT] 
indicators are flashing. For information on formats that can be input and output, refer to 
“Supported Formats” (p. 10).

Does the signal level from the source equipment match the input signal level on the 
VC-30HD?

The RCA connectors on the front panel and the XLR connectors on the rear panel have 
different nominal input signal levels. Connect source equipment that is capable of 
output at the levels shown below.

• RCA (front panel) -20 - 6 dBu

• XLR (rear panel) -8 - +10 dBu

Also, when connection cables containing resistors are used, the signal level from the 
source equipment is lowered. Use a connection cable that does not contain a resistor.

Has communication been established between the VC-30HD and the i.LINK source 
device?

Input from i.LINK equipment is not possible unless communication has been 
established. If the [i.LINK] indicator in [VIDEO INPUT] section is flashing, communication 
has not been established. Wait until the indicator lights up steadily, then perform 
output. 

Is the [HDMI + AUDIO] [VIDEO INPUT] indicator illuminated?

HDMI audio input is canceled when this indicator is illuminated. When you want to 
convert HDMI audio, select [HDMI]. 

Troubleshooting