Hasbro 07951 Manual Do Utilizador

TO INSTALL BATTERIES

Using Phillips/cross head screwdriver,
loosen screw in battery compartment
cover (screw stays attached to cover).
Remove cover. Insert 2 x 1.5V “C” or
R14 size batteries. Alkaline batteries
recommended. Replace cover and
tighten screw.

CAUTION: TO AVOID BATTERY LEAKAGE

1. Be sure to insert the batteries correctly and always follow the toy and

battery manufacturers’ instructions;

2. Do not mix old batteries and new batteries or alkaline, standard

(carbon-zinc) or rechargeable (nickel-cadmium) batteries;

3. Always remove weak or dead batteries from the product.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.
Batteries should be replaced by an adult.

CAUTION:

1. Always follow the instructions carefully. Use only batteries specified and be sure

to insert them correctly by matching the + and – polarity markings.

2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline

batteries.

3.  Remove exhausted or dead batteries from the product.
4.  Remove batteries if product is not to be played with for a long time.
5.  Do not short circuit the supply terminals.
6.  Should this product cause, or be affected by, local electrical interference, move it

away from other electrical equipment. Reset (switching off and back on again or

removing and re-inserting batteries) if necessary.

7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery.

Always remove from the product before recharging. Recharge batteries under

adult supervision. DO NOT RECHARGE OTHER TYPES

OF BATTERIES.