Roland CD-2e Manual Do Utilizador
Recording Acoustic Instruments or Vocals
(continued)
37
Advanced Uses
Recording
Listening
Deleting
Creating a CD
Editing an SD
Appendices
Convenient
Functions
Information
/
Display
Checkin
g
/
Preparations
6
Adjust the input level of the internal mics.
On the CD-2e’s left side, set the [MIC LEVEL] switch to its “MANUAL” position.
fig.rec-intmic02.eps
Turn the [MIC] knob to adjust the input level of the internal mics.
Adjust the loudness of the sound you’re recording. Since you’re not using the line input, turn
the [LINE] knob all the way to the left (off).
the [LINE] knob all the way to the left (off).
While producing the sound that you’ll actually be recording, turn the [MIC] knob to adjust the
input level.
input level.
Adjust the level so that the peak indicator located above the [MIC] knob lights briefly at the
loudest moments of the performance or vocal you’ll be recording.
loudest moments of the performance or vocal you’ll be recording.
fig.rec-intmic03-e.eps
7
Press the [
(Record)] button to enter recording-standby mode.
fig.rec-intmic04-e.eps
8
Press the [
(Play)] button to begin recording.
Start your performance.
fig.rec-intmic05-e.eps
Louder
Quieter
The level meter will move according
to the level of the audio input.
to the level of the audio input.
Peak indicator
At this position
The input level and the recorded result
●
If the input level is high
There is a limit on the level that the CD-2e is able to record.
The peak indicator will light to indicate that the audio input has exceeded this limit (i.e.,
the input is too loud). If you record even though the peak indicator is lit, the recorded
audio will be distorted.
the input is too loud). If you record even though the peak indicator is lit, the recorded
audio will be distorted.
●
If the input level is too low
The recorded audio will not be distorted, but the playback
will not be as loud as it should be.
Blinking
Remote control
Lit
Remote control
CD-2e_e.book 37 ページ ２００７年９月１０日 月曜日 午後８時５７分