Niles Audio 800 Manual Do Utilizador

Existing Construction

1. Drill a 1/8” pilot hole just barely through the
wallboard or drywall (1/2” to 5/8” deep in most
homes) about an inch below the center of your
proposed speaker location (an inch to the side if
you are mounting the speaker horizontally). BE
VERY CAREFUL NOT TO DRILL THROUGH
EXISTING WIRES, PIPES, OR STRUCTURE. IF
YOU FEEL ANY EXTRA RESISTANCE AS YOU
ARE DRILLING, STOP. Cut a piece of coat hanger
equal to the width of the bracket. Bend the wire in
half creating a right angle. Poke the “L-shaped”
wire into the pilot hole and turn it in a complete
circle. If it turns freely, repeat the procedure from

New Construction

Installing the Wings and Bracket
Attach the wings to the bracket by snapping
them into the sides of the bracket. The wings can
be shortened by breaking them along the scored
lines if their length will interfere with a corner or 
eaves. You can mount the bracket horizontally
or vertically (See Figure 2).

Screw one side of the assembled bracket with
wings to the stud using one of the supplied
screws. Level the bracket. Screw the other side
of the bracket assembly to the stud. Two screws
on each side makes for a very secure installation.
Attach the wire to the bracket at the indicated
wire tie points (See Figure 2).

,,,,

,,,,

yyyy

yyyy

,

y

,

y

,

y

,

y

,

y

4 Wire Ties