Extron electronic MBU 123 Folheto

© 2011 Extron Electronics.   All rights reserved.   

68-705-01

05 11

Furniture mount or projector mount the quarter-rack width product using the optional 

mounting kit (part number 70-212-01, furniture; or 70-217-01, projector) as follows:

Attach the mounting brackets to the product with the machine screws provided 
(see the figure on the other side of this card).

If feet were previously installed on the bottom of the unit, remove them.

Hold the unit with the attached brackets against the underside of the table or other 
furniture.  Mark the location of the screw holes of the bracket on the mounting 
surface.

Drill 3/32-inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep in the mounting 
surface at the marked screw locations.

Insert #8 wood screws into the four pilot holes.  Tighten each screw into the mounting 
surface until just less than 1/4 inch of the screw head protrudes.

Align the mounting screws with the slots in the brackets and place the unit against the 
surface, with the screws through the bracket slots.

Slide the unit slightly forward or back, then tighten all four screws to secure the unit in 
place.

Using a locally-supplied nut and bolt, or other appropriate hardware, secure the 
product to a projector mount or other surface by inserting the mounting hardware 
through the slotted hole in the bracket.

Projector Mounting
Bracket

Mounting
Bolt