Hunter Fan 44758 Manual Do Utilizador

Hunter Fan Co.

2500 FRISCO

AVENUE

MEMPHIS, TN 38114

Form No. 44004-01 Rev 09/04/2008

5) Place the Battery Compartment Cover

over the Battery Compartment.

6) For Wall Mounting

a. Replace the Outer Cover as

shown in Figure 8. Use the four screws to

secure the Outer Cover.

b. Use the provided screw to

mount the Remote Sensor on a wall or

other vertical surface. The back of the

Remote Sensor has a Wall-Mount Indent

from which it will hang from the provided

screw. See Figure 9

Figure 8

Wall-Mount

Indent

Figure 9

6) To Set the Remote Sensor on a Table

a. Replace the Outer Cover as

shown in Figure 10. Use the four screws

to secure the Outer Cover.

b. Rest the Remote sensor on

the horizontal surface of your choice.

Figure 10

Indications

TEMP

Normal Temperature Indication
If your Remote Sensor is set to show the

temperature in Celsius, the display will

show the ºC indication next to the tem-

perature. See Figure 11.

TEMP

Figure 11

Temperature Measurement Range
Your Remote Sensor will show tempera-

tures from -40ºF to 122ºF (-40ºC to 50ºC).

If the temperature is greater than 122ºF

(50ºC), the LCD will show “HI”. See Fig-

ure 12A. If the temperature is lower than

-40ºF (-40ºC), the LCD will show “LO”.

See Figure 12B.

Figure 12A

Figure 13

Figure 12B

Low Battery Indication
When your Remote Sensor’s battery is

running low, the LCD will show the flash-

ing Low Battery Indication to remind you

to install two fresh AA Alkaline batteries

at your earliest convenience. See Figure

13. At this point your Remote Sensor will

continue to function normally.

TEMP

Depleted Battery Indication
If your Remote Sensor’s battery is deplet-

ed to the point that the LCD is showing

only the flashing Low Battery Indication,

as in Figure 14, your Remote Sensor has

ceased functioning and will continue in

this condition until two fresh AA Alkaline

batteries are installed. Without further at-

tention, the LCD will eventually go blank.

Your Remote Sensor will return to nor-

mal operation when fresh batteries are

installed.

Figure 14

Troubleshooting

Problem: LCD is Blank.
Solution: Make certain your Remote Sen-

sor’s batteries are 1) installed correctly,

with polarities correctly positioned, and 2)

fresh.

Problem: Thermostat is not showing the

same temperature as the Remote Sensor.
Solution: Make certain you have the cor-

rect Remote Sensor selected at your ther-

mostat (if you are using more than one

Remote Sensor).

If you require further assistance, call Hunter

Fan Technical Support at 1-888-830-1326

from 7am to 7pm Central Time Monday thru

Friday and 8am to 5pm on Saturday.

4. The Remote Sensor Screen will dis-

play the ambient temperature and, in the

bottom-left corner, a channel number

between 0 and 15. See Figure 7. This will

be the channel to which you will set the

thermostat to read the Remote Sensor.

See the Thermostat Instruction Manual,

page 14, Option 8.

TEMP

3. The LCD Display will then show the

normal operating screen. See Figure 7.

NOTE: It may take up to 30 seconds for

the thermostat to "pick-up" the sensor.

Figure 7

Channel