Hunter Fan 99125 Manual Do Utilizador

www.HunterFan.com

1.866.268.1936

M0078-01 • 01/14/14 • © Hunter Fan Company

The Fan Off button only turns the fan 
off. To turn the fan on, press one of the 
fan speed buttons.  

 

 

High

 

 

Medium 

  Low

Within 3 minutes of restoring power 
to the fan, press both the Fan Off 
button and the High button for at least 
4 seconds. Your fan will turn on low to 
indicate successful syncing. If it does 
not, turn off power to your fan, wait 
1 minute then try again. If using the 
transmitter with multiple fans, repeat 
this process for each fan.

The remote must be paired 

before the fan will operate.

Fan Off

High

Quickly press and release either Light 
button to turn the lights off and on. 
Press and hold either light button for 
more than 1 second to activate the 
dimming cycle. Release the light button 
when the desired light level is reached.

Light +

To install the transmitter cradle, 
remove the two screws holding your 
switch cover plate. Do not remove the 
cover plate. Orient the cradle by lining 
up the two mounting holes with those 
on the cover plate. Insert and tighten 
the screws. Do not over tighten. 

Installing or changing  the battery
To access the battery compartment 
remove the small Phillips head screw 
that secures the battery door to the 
transmitter assembly.  Replace with a 
CR2032 battery when necessary. The 
battery should be installed with the 
positive (+) side up.

Phillips 

Head 

Screw

Battery 

Door

Low

Medium

This device complies with part 15 of the FCC Rules.  Operation is subject 

to the following two conditions: (1) this device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation. 
This device complies with RSS-210 of Industry Canada.  Operation is 

subject to the following two conditions: (1) this device may not cause 

interference, and (2) this device must accept any interference, including 

interference that may cause undesired operation of the device.
This equipment has been tested and found to comply with the limits for 

a Class B digital device, pursuant to Part 15 of the FCC Rules.  These 

limits are designed to provide reasonable protection against harmful 

interference in a residential installation.  This equipment generates, uses 

and can radiate radio frequency energy and, if not installed and used 

in accordance with the instructions, may cause harmful interference to 

radio communications.  However there is no guarantee that interference 

will not occur in a particular installation.  If this equipment does cause 

harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged 

to try to correct the interference by one or more of the following 

measures:  Reorient or relocate the receiving antenna, Increase the 

separation between the equipment and receiver, Connect the equipment 

into an outlet on a circuit different from that to which the receiver is 

connected.  Consult the dealer or an experienced radio/TV technician for 

help.  Note: Any changes or modifications to the transmitter or receiver 

not expressly approved by Hunter Fan Company may void one’s authority 

to operate this remote control.

This product conforms to UL Standard 507.

Fan will not start
•  Make sure the power is on at the 
circuit breaker and the wall switch.
•  Make sure the battery is working.
•  Make sure that the transmitter and 
receiver are paired.
•  Check wire connections inside of 
the canopy. 

Remote control of fan is erratic
•  Make sure the battery is installed 
correctly.
• Install a fresh battery. 

Transmitter only works when held 
at close range
•  Change battery.

Lights do not dim
•  Check to see if a CFL bulb is 
installed. The control has a feature 
that automatically detects CFL bulbs 
and turns off dimming if a CFL bulb 
is installed.

CFL bulbs flicker
•  Turn the light switch off and back 
on. Within three minutes, hold down 
the Fan Off button while pressing 
the Dim Down button twice. If the 
problem is not corrected, repeat the 
process up to three times.

•  Press the Fan Off button for at 

least three seconds to initiate the 

Safe-Exit Mode.
•  The lights will flash for visual 

confirmation.
•  The lights will stay on 50% 

brightness for 15 seconds and 

then begin to dim. After a total 

of 30 seconds, the lights will be 

completely off.
Note:  For CFL lighting, the lights 

will stay on 100% brightness 

for 30 seconds. After a total of 

30 seconds, the lights will be 
completely off.

The Safe-Exit Program gives 

you about thirty seconds of 

light when you turn the lights 

off to exit the room before the 
lights go out. To use Safe-Exit:

High

Fan Off

3

2

1

Light -

The Hunter Fan Company makes the following limited warranty to the original purchaser 

of the Control (“Control”): Your Control is warranted to be free from defects in 

material and workmanship for a period of one year from the date of sale. If the Control 

malfunctions or fails within the warranty period due to a defect in material or workmanship 

we will replace it free of charge. IF THE ORIGINAL PURCHASER CEASES TO OWN THE 

CONTROL, THIS WARRANTY AND ANY IMPLIED WARRANTY, INCLUDING BUT NOT 

LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR 

A PARTICULAR PURPOSE, ARE VOIDED. THIS WARRANTY IS IN LIEU OF ALL OTHER 

EXPRESS WARRANTIES. THE DURATION OF ANY IMPLIED WARRANTY, INCLUDING, 

BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR 

FITNESS FOR A PARTICULAR PURPOSE, IN RESPECT TO ANY CONTROL, IS 

EXPRESSLY LIMITED TO THE PERIOD OF THE EXPRESS WARRANTY SET FORTH 

ABOVE FOR SUCH CONTROL. This warranty excludes malfunctions or failures which 

were caused by repairs by persons not authorized by us, mishandling, improper installation, 

modifications, or damage to the Control while in your possession, or unreasonable use. 

This warranty does not apply to batteries or to deterioration or damage to the product 

caused by the use of faulty batteries. To obtain a replacement, return your Control postage 

prepaid along with proof of purchase to Hunter Fan Company Service Department at 

7130 Goodlett Farms Pkwy., Memphis, TN 38016. IN NO EVENT SHALL HUNTER 

FAN COMPANY BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES. 

SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED 

WARRANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR 

CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY 

NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND 

YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

If you have problems installing or operating your fan, do not return this  

 product to the dealer. Call our Consumer Affairs Hotline.

Turn P

ower 

ON

Use the pull-chain switch on the 
fan to set the fan speed to the HIGH 
position before operation.