Kenwood RC-R0507 Manual Do Utilizador

RC-R0507 (En/T)

• The batteries are nearing exhaustion.

• Subwoofer is OFF.

• No Setup codes registered at for the respec-

tive input(s).

• The remote control is set to a different opera-

tion mode.

• Batteries are exhausted.
• The remote control unit is too far away from the

main system, controlling angle is too large, or
there is an obstacle between the receiver and
the remote.

• The audio cords and system control cords are

not connected properly.

• No software is loaded in the source compo-

nent.

• An attempt is made to play a tape which is

being recorded in the cassette deck.

• The remote control has not been set to the

operation mode for the component you wish to
control.

• The microprocessor of the remote control

malfunctions.

• VIDEO2/MONITOR is set to “MONITOR”.

• Replace with new batteries to preserve the

currently registered setup information.

• Turn the subwoofer ON.

• Register a Setup code or Non-IR code at the

respective input(s).

3

• Press VIDEO, AUDIO, or TV to select the

approriate operation mode.

• Replace with new batteries.
• Operate the remote control unit within the

controllable range.

• Connect properly referring to “Setting up the

system”.

• Place software in the source component you

want to play.

• Wait until recording has completed.

• Press the VIDEO, AUDIO, or TV key to activate

the operation mode for the component you
want to control before operation.

5

• Reset the microprocessor.

6

• When the “MONITOR” indicator is displayed,

delete the preset code.

6