RCA HDLP50 Manual Do Utilizador

 Programming the  Remote to Operate 
Other Devices

The universal remote can be programmed to operate many brands of remote-controllable 
VCRs, audio devices, DVD players, cable boxes, satellite receivers and other devices. In 
addition to being programmed to operate your television, it’s already programmed to 
operate some RCA devices. 

A second and third RCA TV can be programmed to any device button, except the TV 
button.

To determine whether the universal remote needs to be programmed to operate one of the 
devices connected to your TV, such as a VCR, do the following:

1.  Turn on the device (in this example, a VCR).

2.  Point the remote at the device.

3.  Press the corresponding device button (in this example, VCR).

4.  Press ON•OFF to see if the VCR responds. If the VCR doesn’t respond, you need to 

program the remote to operate it.

There are three ways to program the remote control to operate other devices: Direct 
Entry, Manual Code Search, and Automatic Code Search. If you have recently purchased 
the device you want to control or if the device has many codes, you might want to try the 
manual code search fi rst.

1.  Turn on the device you want to control.

2.  Look up the brand and code number(s) for the device in the code list at the end of 

this section.

3.  On your remote control, simultaneously press and hold the ON•OFF and MUTE 

buttons (approximately 3 seconds) until a device button remains lit. Then release the 
buttons.

4.  Press and release the device button (SAT•CABLE, VCR, DVD, AUX or AUDIO) 

you want to program. 

5.  Enter a three digit code from the code list.