Invacare 1200 Manual Do Utilizador
OPERATING THE BATH LIFT
11
Transferring into/out of the Lift
Using the Stretcher
NOTE: For this procedure, refer to FIGURE 2.2.
NOTE: To transfer out of the lift, reverse this
procedure.
procedure.
1. Position the lift next to the bed with the
stretcher parallel to the bed.
2. If necessary, unfold the stretcher by
performing the following steps
(Detail “A”):
(Detail “A”):
A. Press and hold the button on the
stretcher frame.
B. Lower the wing arm down to the
desired position.
C. Repeat steps A and B for the
opposite wing arm.
3. Lower the stretcher to the bed height.
4. Roll the resident to the side away from
the stretcher.
5. Push the lift toward the resident.
6. Lock the casters. Refer to Locking and
FIGURE 2.2 Transferring into/out of the
7. Roll the resident onto the stretcher.
8. Install the side guard and straps (not shown).
NOTE: The resident position can be adjusted by raising or lowering the stretcher ends.
Using the Seat
NOTE: For this procedure, refer to FIGURE 2.3 on page 12.
NOTE: To transfer out of the lift, reverse this procedure.
1. Position the lift next to the seated resident.
2. Lower the seat to the resident’s seat height. Refer to Raising/Lowering the Bath Lift on
3. Lock the casters. Refer to Locking and Unlocking the Casters on page 10.
4. Swing one or both armrests out of the way.
Bed
Resident
Stretcher
Lift
Button
Wing
Arm
Stretcher
Frame
DETAIL “A”
NOTE: Stretcher
cover not shown
for clarity.
cover not shown
for clarity.