ONKYO PR-SC886 Manual Do Utilizador

96

■ MultEQ XT
Audyssey MultEQ XT correction is active (see page 58).

■ Dynamic EQ
“Audyssey MultEQ XT” and “Dynamic EQ” becomes 
active (see page 58).

■ Dynamic Vol(Light)
“Audyssey MultEQ XT”, “Dynamic EQ”, and 
“Dynamic Volume (Light Compression Mode)” 
becomes active (see page 58).

This setting prevents loud and soft sounds from being 
much louder and softer respectively than average 
sounds.

■ Dynamic Vol(Heavy)
“Audyssey MultEQ XT”, “Dynamic EQ”, and 
“Dynamic Volume (Heavy Compression Mode)” 
becomes active.

This setting affects volume the most, causing all sounds 
to be of equal loudness.

Notes:
• When the listening mode is set to Direct or Pure 

Audio, no effect will be produced.

• The Equalizer settings have no effect on 176.4/ 

192 kHz input signals.

• This procedure can also be performed on the AV con-

troller by using its [SETUP] button, arrow buttons, 
and [ENTER] button.

w] button to select 

e]/[r] buttons to 

select a speaker.
You can select: “Front”, “Center”, “Sur-
round”, “SurrBack”, or “Subwoofer”.

q]/[w] but-

e]/[r] buttons to adjust the 

level at that frequency.
You can select: “25Hz”, “40Hz”, “63Hz”, 
“100Hz”, “160Hz”, “250Hz”, “400Hz”, 
“630Hz”, “1000Hz”, “1600Hz”, 
“2500Hz”, “4000Hz”, “6300Hz”, 
“10000Hz”, or “16000Hz”. And for the 
subwoofer, “25Hz”, “40Hz”, “63Hz”, 
“100Hz”, or “160Hz”.

The volume at each frequency can be 
adjusted from –6 to +6 dB in 1 dB 
steps.

Low frequencies (e.g., 160Hz) affect 
bass sounds; high frequencies (e.g., 
6300Hz) affect treble sounds.

q]/[w] but-

e]/[r] buttons to select another 

speaker.
Repeat steps 6 and 7 for each speaker.

Press the [SETUP] button.
The setup menu closes.