Tektronix 8.00E+04 Manual Do Utilizador
Getting Started
8
80E00 Electrical Sampling Modules User Manual
To install a sampling module, first turn off the instrument using the front-panel
On/Standby switch. Then place the sampling module in a compartment and
slowly push it in with firm pressure. Once the sampling module is seated, turn
the hold-down screw on the sampling module to tighten the sampling module
into place. See Figure 4.
On/Standby switch. Then place the sampling module in a compartment and
slowly push it in with firm pressure. Once the sampling module is seated, turn
the hold-down screw on the sampling module to tighten the sampling module
into place. See Figure 4.
CAUTION. To prevent damage to the sampling module or instrument, never install
or remove a sampling module when the instrument is powered on or when either
input connector is unprotected.
or remove a sampling module when the instrument is powered on or when either
input connector is unprotected.
NOTE. When removing your sampling module, first loosen the hold-down screw,
and then use the sampling module ejector on the main instrument to eject the
sampling module.
and then use the sampling module ejector on the main instrument to eject the
sampling module.
Small-compartment
ejectors
ejectors
Electrical sampling module
Hold-down screw
Figure 4: Installing a sampling module
Module Installation