Ariens 932503 - 724 Manual Do Utilizador

GB - 26

(Figure 19):

1. Shut off engine, remove key, disconnect 

spark plug wire and allow unit to cool 
completely.

2. Tip the unit up onto front housing on a 

level surface.

3. Remove locknut and bolts from wheel 

axles and remove wheels.

4. Remove two (2) bolts from top of bottom 

cover.

5. Loosen two (2) bottom screws and slide 

cover off.

6. Remove hair pin and washer from shift 

rod. Disconnect shift rod from lower 
speed selector arm. Reinstall hairpin and 
washer on rod.

7. Remove four (4) nuts from bearing cap on 

left side of unit.

8. Reinstall one nut to keep the inside 

bearing cap in place.

9. Remove bearing cap/bushing and washer 

from right side of unit.

10. Reinstall nuts on screws through side 

frame to keep screws in place.

11. Carefully tap two (2) roll pins out of center 

and right end of shaft.

12. Slide friction disc assembly and hex shaft 

to the right until the left end of shaft is 
clear of left bearing. Tap lightly if 
necessary, to loosen. The shaft slides out 
of the small pinion gear and washer.

13. Carefully lift shaft and friction disc out of 

unit. As you remove the assembly, the 
washers between the bearing and sliding 
forks will be loose. Do not lose the 
washers. 

1. Remove three (3) hex bolts and nuts 

holding friction disc to shift carrier. 

2. Remove the old friction disc. Put the new 

friction disc in place, flat side to the shift 
carrier.

3. Reinstall the three (3) bolts and nuts into 

the new friction disc and hub. Torque to 
5-6 lbf-ft (6.8 to 8.13 N•m).

1. Reinstall the shift carrier, the small pinion 

gear and washer onto the hex shaft. The 
washer goes between the bearing and 
the pinion gear.

2. Slide the shaft and attached parts into the 

frame, through the right side hole first, 
then the left. Pinion gear must mesh with 
the large gear.

3. Reinstall the bearing and outside bearing 

cap on the left side of the frame.

4. On the right side of the frame, place the 

washer on the end of the shaft.

5. Reinstall the bearing cap/bushing on the 

right side of frame.

6. Reinstall the flange bearing and washers 

into the shift forks. Be sure the washers 
are inside the forks.

7. Reinstall roll pins in shaft. Be sure pins 

are centered in shaft.

8. Reinstall shift rod with hairpin and 

washer.

9. Reinstall tires with bolts and locknuts.

10. Set unit upright.
11. Replace spark plug wire on spark plug.

CAUTION: Before tipping unit, 
remove enough fuel so that no spills 
occur. 

1. Hex shaft
2. Friction Disc
3. Hex Bolts & Nuts
4. Shift Carrier
5. Roll Pins
6. Washers

7. Bearing Cap 

Screws

8. Bearing Cap/

Bushing

9. Clutch Fork

10.Large Gear
11.Pinion Gear

1

2 3

4

5

6

9

11

10

8

7

OS2002

Figure 19

5

6

6