Uniden 880 Manual Do Utilizador

11

Weather Scan mode allows the radio to move to the next weather 

channel if no signal is detected after 3 seconds. Set Weather Scan mode 

to ON or OFF through the menus.
1.  Press MENU/OK to activate the menus. COLOR displays.

2.  Turn the Channel Selector knob to cycle through the menu op-

tions until WXSCAN displays.

3.  Press MENU/OK. ON displays.

4.  Press MENU/OK to set Weather Scan mode to ON or turn the se-

lection knob until OFF displays and then press MENU/OK to set it. 
WXSCAN

 displays again.

Left at these setting (WX mode, WX Scan), you will hear only weather 

broadcasts and Weather Alert signals. To use your CB radio normally 

while monitoring weather alerts, press WEATHER again.

Weather Alert mode only operates when you are in CB mode; it does not 

operate in Weather mode. In CB mode, the radio sounds an alert tone 

when it detects a 1050Hz tone on a weather channel.

Press and hold WEATHER to turn Weather Alert on. The WEATHER LED 

turns on.

You can select channels to store into memory and then scan only those 

channels. 

Save Channels Into Memory
1.  Tune to a channel in CB mode.

2.  Press and hold MEM/SCAN until SAVE appears (about 2 seconds).

3.  Release MEM/SCAN. 

4.  The radio stays on the saved channel.